this was supposed to be quite simple backpack. But somehow, since i wanted to sew the zipper differently than i usually did, I didnt set up a step by step sewing procedure properly. I just sew as usual. Apparently, I sew in a wrong order so the result was not precise and the difficulty increased.
i also made a pattern mistake which i wanted to make side pockets flatter a bit but ended up with sewing difficulty due to thickness. 😰😰. I added a strap to make it thicker or fatter. So you can see there’s kind of ‘additional strap’ on the pockets. Yet, since it’s emergency correction, the precision of the stripe, the position of the pockets (the mark was quite disappeared and i was too lazy to do it again bcs the pieces were half assembled already when i fixed the pockets) and the sewing are not good. 😞. aaaaaand so does the zipper part. it wasnt precise too.
the lining inside should be modified too. separate pattern should be made. I didnt do it bcs i didnt think it would be necessary. I made the pattern very simple that actually it caused me difficulty in sewing. It was same to the lining. I should make separate different lining pattern but I used main fabric pattern
I want to write abt the zipper sewing later. I plan to make one more later. I hope i wont forget to take a picture. haha.
Also want to write abt lining pattern too. I dont plan to write a whole tutorial though. But if i have time, may be.
Few things to note (again) when making new project (though it looks like not new):
- set up a step-by-step sewing procedure.
- don’t just use main pattern as lining pattern.
- with that kind of pockets, it’s better to give more sewing allowance rather than 0.5cm or less. It’s even better to give at around 1.7-2cm.
- Better no interfacing used on pocket strap to be sewn on the main body. Interfacing will add thickness. Or even if it’s used, make it smaller than pattern, so the side to be sewn is still interfacing-less.